Trigger Reconnect Mode; Maximum Link Attempts - Honeywell Xenon Series User Manual

Event
Scanner out of range
Base or Access point reset
(firmware upgrade or power
cycle)
Scanner power down due to
Power Time-Out Timer
setting
Scanner reset due to
firmware upgrade
Scanner reset due to battery
change
Scanner placed in different
base unit

Trigger Reconnect Mode

Note: This setting is only supported by Granit 1981i/1911i.
Trigger Reconnect allows you to control the relink process rather than having it
occur automatically. First scan
Reconnect On. The scanner begins the relink process when the trigger is pulled.
Default = Trigger Reconnect On.

Maximum Link Attempts

The Maximum Link Attempts setting controls the number of times the scanner
tries to form a connection with a base or an Access Point. During the connection
setup process, the scanner transmits in order to search for and connect to a base
or an Access Point. In order to prevent continuous transmissions that could inter-
76
*Trigger Reconnect On
Auto Reconnect On
Relink occurs automatically. If
maximum number of link attempts
is unsuccessful, then the scanner
must be relinked by either pulling
the trigger, placing the scanner in
the base, or scanning the Access
Point linking bar code. (See
Maximum Link Attempts
76.)
Scanner behaves as if out of range.
Trigger must be pulled, Access Point linking bar code must be
scanned, or the scanner must be placed in the base unit to relink.
(Note: scanner relinks on power up, but powers on due to one of the
above actions.)
Relink occurs automatically.
Relink occurs automatically.
Relink to new base occurs automatically.
Auto Reconnect Off
Auto Reconnect Off
The scanner is relinked by
pulling the trigger, or scanning
the Access Point linking bar
code.
on page
No attempt to relink made
while base or Access Point is
powered off. Trigger must be
pulled to initiate relinking.
(page 75), then scan Trigger
Trigger Reconnect Off
Xenon/Granit User Guide