Preferred Symbology Default; Output Sequence Overview; Output Sequence Editor; To Add An Output Sequence - Honeywell Xenon Series User Manual

encountered. Scan the bar code below, then set the delay (from 1-3,000 millisec-
onds) by scanning digits from the
then Save. Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their default val-
ues.

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the bar codes are scanned. You can
define up to 15 bar codes in an output sequence.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric
symbols from the
trigger while reading each bar code in the sequence.

To Add an Output Sequence

An output sequence is created using a string of serial commands that is sent to the
scanner. This string is most easily sent to the scanner using the EZConfig software
tool (see
accomplish this by scanning alphanumeric bar codes (see the
Chart,
1. If you are using bar codes to create your output sequence, scan
2. Code I.D.
138
Programming Chart,
EZConfig Cloud for Scanning Introduction
beginning on page 353).
Sequence on page 142.
On the Symbology Charts
to apply the output sequence format. Make a note of the hex value for that
symbology. If you are using bar codes to create your output sequence, scan the
2 digit hex value from the
Programming Chart,
Preferred Symbology Time-out
Preferred Symbology Default
beginning on page 353. You must hold the
on page 339, find the symbology to which you want
Programming Chart,
beginning on page 353,
on page 263). You can also
Programming
Enter Output
beginning on page 353.
Xenon/Granit User Guide