Example Wizard - Siemens SINAMICS Series Operating Instructions Manual

Intelligent operator panel. intelligent commissioning and application configuration tool

Hide thumbs Also See for SINAMICS Series:

Table of Contents

4.1

Example wizard

Overview of wizards

The following example of how wizards work on the IOP are purely for demonstration purpose

only. It should be understood that the screens, questions and steps for each wizard are

dependent on the following influences:

● The firmware version of the IOP in use.

● The firmware version of the Control Unit to which the IOP is fitted.

● The type of Control Unit to which the IOP is fitted - not all Control Units have the same

functionality and this will change the structure of the IOP menus including the type and

number of wizards that will be offered to the user.

Intelligent Operator Panel (IOP)

Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB

CAUTION

Before commissioning an application

Prior to using the a wizard, it is essential that the user's Control Unit and Power Module

have been installed and wired correctly, in accordance with the requirements of the

user's application. This is extremely important in the case of commissioning safety-

integrated applications. All inputs and outputs must be defined and configured before

any commissioning can take place, including the observation and adherence of all local,

national and international safety regulations required for the user's application and all

devices utilitzed by the user's application.

Wizards

4.1 Example wizard

Table of Contents