Siemens SINAMICS Series Operating Instructions Manual page 12

Intelligent operator panel. intelligent commissioning and application configuration tool

Hide thumbs Also See for SINAMICS Series:

Table of Contents

Overview

2.2 Layout and functions

DEMO mode

To enter the DEMO mode it is necessary to do a long press of the ESC key or INFO key

during the power-up cycle. The IOP must be power cycled again to exit the DEMO mode.

DEMO mode allows the IOP to be used for demonstration purposes without affecting the

Inverter to which it is connected. Menus can be navigated and functions selected, but all

communications with the Inverter are blocked to ensure that the Inverter does not react to

any commands issued from the IOP.

Locking and unlocking the keypad

The keypad can only be locked once the power-up cycle has been completed. If the keys are

actived before the power-up cycle is completed, the IOP will enter the DEMO mode.

To lock the IOP keypad press ESC and INFO simultaneously for 3 seconds or more. To

unlock the keypad press ESC and INFO simultaneously for 3 seconds or more.

Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB

Intelligent Operator Panel (IOP)

Table of Contents