Siemens SINAMICS Series Operating Instructions Manual page 17

If the Wizard menu is not required, then press Esc to return to
the normal status screen.
Language selection
To select the language that the IOP should display, the following actions should be
performed:
1. Rotate the Wheel to select "Menu".
2. Press the Wheel to confirm selection.
3. The "Menu" screen is displayed.
4. Rotate the Wheel to select "Extras".
5. Press the Wheel to confirm selection.
6. The "Extras" screen is displayed.
7. Rotate the Wheel to select "Panel Settings"
8. Press the Wheel to confirm selection.
9. Rotate the Wheel to select the required language.
10. Press the Wheel to confirm selection.
11. The "Language" screen is displayed.
12. Rotate the Wheel to select the language.
13. Press the Wheel to confirm selection.
14. The selected language will now be used by the IOP.
15. The IOP will return to the "Extras" menu.
16. Press "Esc" for more than 3 seconds to return to the
"Status" screen.
Additonal languages are available for the IOP. For further information, please see Firmware
and language upgrade (Page 20).
Intelligent Operator Panel (IOP)
Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB
Installation
3.2 Initial Set-up
17