Procedure 3.3 - Displaying The Odometer - Precor C576i Service Manual

Procedure 3.3 - Displaying the Odometer

Procedure
1. Start pedalling and continue to pedal as you perform step 2.
With the PRECOR C576i banner scrolling, press keys RESET,6,5, sequentially.
2.
The message INFORMATION DISPLAY will be displayed for a few seconds.
3.
The message ODOMETER will be displayed followed by the total number of strides
4.
accumulated. Press the ENTER key to advance to total strides.
The message TOTAL STRIDES will be displayed followed by the total number of strides
5.
logged on the C576i. Press the ENTER key to advance to hour meter.
The message HOUR METER will be displayed followed by the total number of hours that
6.
the C576i has been in use. Press the ENTER key to advance to software version.
The message SOFTWARE VERSION will be displayed followed by the upper software part
7.
number UPPER APP XXXX-XXX. Use the
number UPPER BOOT XXXXX-XXX and lower software part number
LOWER XXXXX-XXX. Press the ENTER key to advance to error log.
The message ERROR LOG will be displayed followed by the error in log position 1. Each
8.
log entry shows the log position, the stride count when the error occurred and the hour
meter when the error occurred. For example; 1 ER21 123456 STR 45678 HRS. The error
log can record up to ten error conditions. The error code in position one will be the most
recent error and the error in position ten will be the oldest error. If more than ten errors have
been logged, only the ten most recent will be displayed. Use the
through the log. Pressing and holding the QUICK START key for four seconds will clear the
log. Press the ENTER key to advance to the serial number display.
If a serial number has been entered it will be displayed otherwise NO SERIAL NUMBER will
9.
be displayed. Press the ENTER key to exit the odometer program.
C576i Self Powered Elliptical Fitness Crosstrainer
and keys to display the boot software part
and keys to move
Page 9