Procedure 7.12 - Replacing A Stairarm Wheel - Precor C576i Service Manual

Procedure 7.12
Procedure
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
1. Remove the lift cover per Procedure 7.2.
2. Grasp the center ramp cover and lift it upwards to unsnap it from the ramp. Remove the
center ramp cover from the EFX and set it aside.
3. Remove the two screws that fasten the ramp end cap to the ramp. Remove the ramp end
cap. Refer to Diagram 7.11.
Diagram 7.11 -Ramp Assembly
Center Ramp
Cover
Right Side
Ramp Trim
Ramp
End Cap
4. The left side and/or right side ramp trim will need to be removed in order to access the
stairarm wheels.
5. Loosen, but do not remove, the five screws that fasten ramp trim(s) required to access the
wheel(s) being replaced. Slide the ramp trim(s) off the front of the ramp.
6. Remove the screw retaining the wheel being replaced. Refer to Diagram 7.12. Slide the
wheel off the stairarm axle.
- Replacing a Stairarm Wheel
C576i Self Powered Elliptical Fitness Crosstrainer
Left Side
Ramp Trim
Page 55