Procedure 7.7 - Replacing A Incline Motor - Precor C576i Service Manual

Procedure 7.7 - Replacing a Incline Motor

1. Remove upper and front cover sections per Procedure 7.1.
2. Remove the hitch pin from the clevis at the lower incline motor mount. Remove the clevis
pin from the lower incline motor mount.
3. Carefully lift the incline motor out of its mount and set it on the floor in front of the EFX, Refer
to Diagram 7.9.
Diagram 7.9 - Incline Motor
Intermediate Cable
Clevis Pin
4. Disconnect the intermediate cable from the incline motor cable.
5. Remove the two bolts that fasten the incline motor yoke into the ramp. Refer to Diagram
7.16.
6. Carefully, slide the incline motor yoke out of the ramp and lower the ramp until it is resting
on the frame.
7. Thread the incline yoke assembly off of the incline motor's drive screw.
8. Thread the incline yoke assembly, removed in step 7, onto the replacement incline motor's
drive screw.
C576i Self Powered Elliptical Fitness Crosstrainer
Incline Motor
Hitch Pin
Page 47