Procedure 7.20 - Replacing An External Power Input Jack - Precor C576i Service Manual

Procedure 7.20 - Replacing an External Power Input Jack

1. Remove the left and right side rear covers sections per Procedure 7.1.
2. Disconnect the J4 connector from the lower PCA.
Diagram 7.23 - Power Input Jack Mounting
3. Remove the nut that fastens the external power input jack to the rear cover support. Refer to
Diagram 7.23.
4. Remove the power jack's wiring from the wire clips and discard the power jack and wiring.
5. Fasten the replacement external power input jack into the cover with the mounting nut
provided with the power input jack.
6. Route the power input jack wiring through the wire clips to the lower PCA. Connect the plug
on the power input jack wiring to the J4 connector on the lower PCA.
7. Replace the left and right side rear covers.
8. Check the operation of the EFX as described in Section Four.
C576i Self Powered Elliptical Fitness Crosstrainer
External Power
Supply
Input jack
Page 69