Yamaha FJR1300N 2001 Service Manual page 441

BALANCERS
3. Install:
• balancer shaft 1
NOTE:
@
• Align the punch mark a in the balancer
weight with the oil hole b in the upper crank-
case.
• Make sure that the front balancer gear teeth
and the primary drive gear teeth mesh cor-
rectly.
• Make sure that the slot c is facing in the
direction indicated in the illustration when
installing the balancer shaft.
4. Install:
• balancer lever 1
• balancer lever bolt 2
NOTE:
Temporarily tighten the balancer lever bolt.
5. Tighten:
• balancer shaft 1
NOTE:
Tighten the balancer shaft to the specified
torque by turning it counterclockwise, and then
turn it one scale back on the balancer lever
scale.
6. Tighten:
• balancer lever bolt 1
• balancer shaft pinch bolt 2
NOTE:
Make sure that the balancer shaft does not
rotate.
5 - 122
ENG
LT
0.4 Nm (0.04 m · kg)
14 Nm (1.4 m · kg)
10 Nm (1.0 m · kg)