Disassembling The Crankcase - Yamaha FJR1300N 2001 Service Manual

CRANKCASE
EAS00384

DISASSEMBLING THE CRANKCASE

1. Remove:
• crankcase bolts
NOTE:
@
• Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
• Loosen the bolts in decreasing numerical
order (refer to the numbers in the illustra-
tion).
• The numbers embossed on the crankcase
indicate the crankcase tightening sequence.
2. Place the engine upside down.
3. Remove:
• lower crankcase
CAUTION:
@
Tap on one side of the crankcase with a
soft-face hammer. Tap only on reinforced
portions of the crankcase, not on the
crankcase mating surfaces. Work slowly
and carefully and make sure the crankcase
halves separate evenly.
M9 × 115 mm bolts:
M8 × 65 mm bolts:
M8 × 50 mm bolts:
M6 × 80 mm bolts:
M6 × 65 mm bolts:
M6 × 65 mm bolts:
M6 × 55 mm bolts:
M6 × 45 mm bolts:
4. Remove:
• dowel pins
5 - 86
ENG
1 ~ 0
A
B
M, O
C, D
I, L, N, P
E ~ H, J, K, Q ~ T
U