Commands For Configuring And Monitoring Sonet Ports; Configuring Sonet Framing - Extreme Networks PoS Installation And User Manual

Commands for Configuring and Monitoring SONET Ports

Table 3-2 describes the ExtremeWare commands for configuring and monitoring SONET
ports. Each command is described in detail in the sections that follow.
Table 3-2: SONET Port Commands
Command
config sonet clocking [line | internal]
ports <portlist>
config sonet framing [sonet | sdh]
ports <portlist>
config sonet signal label [auto | <hex_octet>]
ports <portlist>
config sonet threshold signal degrade
<error_rate> ports <portlist>
config sonet threshold signal fail <error_rate>
ports <portlist>
config sonet trace path <id_string>
ports <portlist>
config sonet trace section [<id_byte> |
string <id_string>] ports <portlist>
show sonet {<portlist>} {detail}
unconfig sonet ports <portlist>

Configuring SONET Framing

You can configure each port for framing that complies with either the SONET standard
or the SDH standard. SONET is primarily an American standard; SDH is the
international version. The default is SONET.
To configure the framing for the specified SONET port, use the following command:
config sonet framing [sonet | sdh] ports <portlist>
The following command example selects SDH framing for port 1 of the PoS module
installed in slot 8 of the BlackDiamond switch.
config sonet framing sdh ports 8:1
Packet Over SONET Module Installation and User Guide
Configuring and Monitoring SONET Ports
Description
Configures the clocking source for the specified
SONET ports.
Configures the framing type for the specified
SONET ports.
Configures the Signal Label value for the
specified SONET ports.
Configures the Signal Degrade threshold for the
specified SONET ports.
Configures the Signal Failure threshold for the
specified SONET ports.
Configures the Path Trace Identifier string for the
specified SONET ports.
Configures the Section Trace Identifier for the
specified SONET ports.
Displays SONET port status.
Resets the configuration parameters of the
specified SONET ports to their default values.
3-13