Tools; I/O Module Slot Locations - Extreme Networks PoS Installation And User Manual

Tools

You need the following tools to install an Extreme Networks I/O module in a
BlackDiamond 6800 series chassis.
• ESD-preventive wrist strap and grounding leash that is provided with the
BlackDiamond 6800 series chassis.
• Number 1 Phillips-head screwdriver.
• Optical-fiber cable of the type appropriate to the I/O module version you plan to
install (see "Cables and Connectors" on page 2-3 for more information about cable
and connector requirements).

I/O Module Slot Locations

Figure 2-1 shows the I/O module slot locations in the BlackDiamond 6800 series chassis.
You can install the PoS module in any of the numbered slots labeled slots 1 through 8.
I/O modules do not fit in slots A or B. When you are installing a new PoS module, you
must first remove the blank filler from the available slot.
To ensure a sufficient flow of cooling air across the component side of the PoS
module, install the PoS module in the BlackDiamond 6800 series chassis so that
another module, a blank filler, or the far right chassis wall covers the component
side of the module.
Packet Over SONET Module Installation and User Guide
Preparing for Installation
2-5