Default Configuration For Bcp - Extreme Networks PoS Installation And User Manual

Configuring the PoS Module
configuration values will bring up the ports as members of the default VLAN.
However, the commands to enable BCP together with the default SONET values (see
Table 3-1) are listed below for reference. The command
will also reset these default values.
<portlist>
BlackDiamond 1
1 2 3 4 A B 5 6
Figure 3-1: Default configuration for BCP
Configuring Default SONET and PPP Settings
The following configuration commands apply to the PoS module installed in slot 8 of
BlackDiamond switch 1, as shown in Figure 3-1.
config ppp echo 1 5 ports 8:1
config ppp authentication off ports 8:1
config ppp quality off ports 8:1
config ppp user "extreme" encrypted "f7P*8aPO+86+'RL8E?MDZBJV'F)UC.-"
ports 8:1
config ppp bcp on ports 8:1
config ppp ipcp off ports 8:1
config ppp pos checksum 32 ports 8:1
config ppp pos scrambling on ports 8:1
config ppp delayed-down-time 1 ports 8:1
3-4
7 8
8:1
BCP
unconfig ppp ports
BlackDiamond 2
1 2 3 4 A B 5
1:3
Packet Over SONET Module Installation and User Guide
6 7 8
PoS_005