Commands For Configuring And Monitoring Aps; Aps Commands - Extreme Networks PoS Installation And User Manual

Configuring the PoS Module

Commands for Configuring and Monitoring APS

Table 3-16 lists the ExtremeWare APS commands that support the PoS module. Each
command is described in detail in the sections that follow.
Table 3-16: APS Commands
Command
config aps <group#> [nonrevert |
revert <minutes>]
config aps <group#> add <port> [working |
protection <ipaddress>]
config aps <group#> authenticate [off |
on <string>]
config aps <group#> delete <port>
config aps <group#> force [off | working |
protection]
config aps <group#> lockout [off | on]
config aps <group#> manual [off | working |
protection]
config aps <group#> timers <seconds>
<consecutive_misses>
create aps <group#>
delete aps <group#>
disable aps
enable aps
show aps {<group#>} {detail}
unconfig aps <group#>
3-86
Description
Configures APS operation in either nonrevertive
or revertive switching mode.
Adds a SONET port to an APS group.
Configures authentication of APS control
messages.
Deletes a SONET port from an APS group.
Requests that an APS group be forced to use a
specified line as the active line.
Controls whether a switch to the protection line is
locked out.
Manually determines whether an APS group uses
its working line or its protection line as the active
line.
Sets the values of the timers used in the APS
hello protocol that is exchanged between the
working and protection switches for an APS
group.
Creates an APS group with the specified group
number.
Deletes the specified APS group.
Disables the APS function for an entire switch.
Enables the APS function for an entire switch.
Displays APS group status information.
Resets the APS group configuration parameters
to their default values.
Packet Over SONET Module Installation and User Guide