Configuring the PoS Module
Configuring and Monitoring SONET Ports
In addition to the ExtremeWare commands for configuring slot and port behavior that
are described in the ExtremeWare Software User Guide, this section describes the
commands used to configure SONET link attributes.
This section provides information on the following topics:
• Commands for Configuring and Monitoring SONET Ports on page 3-13
• Configuring SONET Framing on page 3-13
• Configuring SONET Clocking on page 3-14
• Configuring the Signal Fail Threshold on page 3-14
• Configuring the Signal Degrade Threshold on page 3-15
• Configuring the Section Trace Identifier on page 3-15
• Configuring the Path Trace Identifier on page 3-16
• Configuring the Signal Label on page 3-17
• Resetting SONET Configuration Parameter Values on page 3-17
• Displaying SONET Port Status Information on page 3-18
Table 3-1 on page 3-5 describes the configurable SONET link parameters and their
default values, Table 3-2 on page 3-13 describes the ExtremeWare commands for
configuring and monitoring SONET ports, Table 3-3 on page 3-18 lists the supported
SONET statistics, and Table 3-4 on page 3-19 describes the SONET events and their
associated actions.
3-12
Packet Over SONET Module Installation and User Guide