Commands and Functions Not Supported
None of the ExtremeWare commands associated with the following functions are
supported for PoS ports:
• Extreme Standby Routing Protocol (ESRP)
• Dynamic Link Context System (DLCS)
™
• Intra-Subnet QoS
• Remote Monitoring (RMON)
Table A-4 is an alphabetical list of the existing ExtremeWare commands that are not
supported for the PoS module.
Table A-4: Summary of Commands Not Supported for PoS Ports
Command
config gvrp {listen | send | both | none]
ports <portlist>
config mirroring add [vlan <name> |
port <port> | vlan <name> ports <portlist>
config ports <portlist> auto off {speed [10 |
100 | 1000]} duplex [half | full]
config ports <portlist> auto on
config vlan <name
1
> [add | delete]
ports <portlist> {tagged | untagged}
{nobroadcast}
2
config vlan <name
> protocol
<protocol_name>
disable learning ports <portlist>
enable dlcs ports <portlist>
enable esrp vlan <name>
A-8
(ISQ)
Description
The Generic VLAN Registration Protocol (GVRP)
is not supported on PoS module ports.
Port mirroring is not supported on PoS module
ports.
This command is an Ethernet-specific command.
This command is an Ethernet-specific command.
Usage restrictions apply. PoS I/O module ports
do not support Protocol-Based VLANs or MAC
Address VLANs; otherwise, PoS ports support
the optional tagged and untagged keywords
when BCP is enabled and ignore them when
IPCP is enabled.
Usage restrictions apply. The command
config vlan <name> protocol any is
supported, because it can be used to configure
the default VLAN for PoS ports.
Learning is always enabled.
No DLCS functions are supported for a PoS port
when the port is a member of a VLAN.
Not supported when a PoS port is a member of
the VLAN specified as <name>.
Packet Over SONET Module Installation and User Guide