New Extremeware Commands - Extreme Networks PoS Installation And User Manual

New ExtremeWare Commands

Table A-1 lists the new ExtremeWare commands that have been added to support the
PoS module. For more information on these commands, see Chapter 3.
Table A-1: New ExtremeWare Commands
Command
config aps <group#> [nonrevert |
revert <minutes>]
config aps <group#> add <port> [working |
protection <ipaddress>]
config aps <group#> authenticate [off |
on <string>]
config aps <group#> delete <port>
config aps <group#> force [off | working |
protection]
config aps <group#> lockout [off | on]
config aps <group#> manual [off | working |
protection]
config aps <group#> timers <seconds>
<consecutive_misses>
config diffserv dscp-mapping
<input_codepoint>/<output_codepoint>
ports <portlist> {egress {no-congestion |
congestion} | ingress}
config dot1q tagmapping
<input_vlanid/output_vlanid> ports <portlist>
{egress {priority <priority>} | ingress
{priority <priority>}}
config dot1q tagnesting {<vlanid> |
<vlanid_range>} [off | pop |
push <new_vlanid> {priority <priority>}]
ports <portlist> {egress | ingress}
config flowstats export {<group#>} [add |
delete] [<ipaddress> | <hostname>]
<udp_port>
A-2
Description
C
onfigures APS operation in either nonrevertive
or revertive switching mode.
Adds a SONET port to an APS group.
Configures authentication of APS control
messages.
Deletes a SONET port from an APS group.
Requests that an APS group be forced to use a
specified line as the active line.
Controls whether a switch to the protection line is
locked out.
Manually determines whether an APS group uses
its working line or its protection line as the active
line.
Sets the values of the timers used in the APS
hello protocol that is exchanged between the
working and protection switches for an APS
group.
Configures a mapping between an input DiffServ
code point (DSCP) and an associated output
DSCP for the specified PoS ports.
Configures the VLAN tag mapping tables for a
PoS port.
Configures the VLAN tag nesting attributes for a
PoS port.
Configures the flow-collector devices to which
NetFlow datagrams are exported.
Packet Over SONET Module Installation and User Guide