Commands For Configuring And Monitoring Sonet Features On Atm Ports - Extreme Networks BlackDiamond 6800 Installation And User Manual

Table 3-3: SONET Parameters and Values (continued)
Parameter
J0 Section Trace string
J1 Path Trace identifier string
C2 Signal Label
1. B2 bit error rate (BER) threshold; a Signal Failure (SF) event is generated if the BER exceeds the
specified threshold.
2. B2 bit error rate (BER) threshold; a Signal Degrade (SD) event is generated if the BER exceeds the
specified threshold.
3. The default value of 1 is per ANSI T1.105-1995. This parameter applies only when SONET framing is
configured on the port.
4. This parameter applies only when SDH framing is configured on the port.
5. When SDH framing is configured on the port, only the first 15 characters of the string are applied.
6. Set automatically based on synchronous payload envelope (SPE) payload type.
Commands for Configuring and Monitoring SONET
Features on ATM Ports
Table 3-4 describes the ExtremeWare commands for configuring and monitoring SONET
related attributes on ATM ports. Each command is described in detail in the sections
that follow.
Table 3-4: SONET Features on ATM Ports Commands
Command
config sonet clocking [line | internal]
ports <portlist>
config sonet framing [sonet | sdh]
ports <portlist>
config sonet signal label [auto | <hex_octet>]
ports <portlist>
config sonet threshold signal degrade
<error_rate> ports <portlist>
config sonet threshold signal fail <error_rate>
ports <portlist>
config sonet trace path <id_string>
ports <portlist>
config sonet trace section [<id_byte> |
string <id_string>] ports <portlist>
Asynchronous Transfer Mode (ATM) Module Installation and User Guide
Possible Values
4
Maximum of 15 characters
5
Maximum of 62 characters
6 0 through xFF
Configuring and Monitoring SONET
Default Value
15 NULL characters
NULL characters
auto
Description
Configures the clocking source for the specified
ATM ports.
Configures the framing type for the specified
ATM ports.
Configures the Signal Label value for the
specified ATM ports.
Configures the Signal Degrade threshold for the
specified ATM ports.
Configures the Signal Failure threshold for the
specified ATM ports.
Configures the Path Trace Identifier string for the
specified ATM ports.
Configures the Section Trace Identifier for the
specified ATM ports.
3-15