New Extremeware Commands - Extreme Networks BlackDiamond 6800 Installation And User Manual

New ExtremeWare Commands

Table A-1 lists the new ExtremeWare commands that have been added to support the
ATM module. For more information on these commands, see Chapter 3.
Table A-1: New ExtremeWare Commands
Command
config atm add pvc <vpi | vci> encap [l2 | ip
peer-ipaddress <ipaddress>] vlan <name>
ports <portlist>
config atm delete pvc [<vpi | vci> | all] {vlan
<name>} ports <portlist>
config atm scrambling [on | off] ports
<portlist>
config diffserv dscp-mapping
<input_codepoint>/<output_codepoint>
ports <portlist> {egress {no-congestion |
congestion} | ingress}
config dot1q tagmapping
<input_vlanid/output_vlanid> ports <portlist>
{egress {priority <priority>} | ingress
{priority <priority>}}
config dot1q tagnesting {<vlanid> |
<vlanid_range>} [off | pop |
push <new_vlanid> {priority <priority>}]
ports <portlist> {egress | ingress}
config red min-threshold <percent>
ports <portlist>
config sonet clocking [line | internal]
ports <portlist>
config sonet framing [sonet | sdh]
ports <portlist>
config sonet signal label [auto | <hex_octet>]
ports <portlist>
A-2
Description
Configures the specified PVC configuration on
the specified ATM port(s). The valid VPI range is
from 0 to 15. The valid VCI range is from 17 to
4095.
Deletes the specified PVC configuration on the
specified ATM port(s) The optional vlan
parameter may be used to delete the PVC
configuration on a specific VLAN. If the vlan
parameter is omitted, the PVC configuration is
deleted for all VLANs on the specified ATM
port(s).
Configures an ATM port to scramble the cell
payload on the specified ATM port(s). The default
setting is on.
Configures a mapping between an input DiffServ
code point (DSCP) and an associated output
DSCP for the specified ATM ports.
Configures the VLAN tag mapping tables for an
ATM port.
Configures the VLAN tag nesting attributes for an
ATM port.
Configures the minimum queue length threshold
for RED operation on the specified ATM ports.
Configures the clocking source for the specified
ATM ports.
Configures the framing type for the specified
ATM ports.
Configures the Signal Label value for the
specified ATM ports.
Asynchronous Transfer Mode (ATM) Module Installation and User Guide