Resetting Sonet Configuration Parameter Values; Displaying Sonet Status Information On Atm Ports - Extreme Networks BlackDiamond 6800 Installation And User Manual

Configuring the ATM Module
3 Compare the contents of the received C2 field (Signal Label value) with the contents
of the transmitted C2 field.
If no Signal Label value is specified, the command defaults to , which causes the
auto
value of the Signal Label field to be set automatically based on standard conventions for
the given payload type.
The following command example sets the Signal Label to the hexadecimal value CF for
port 1 of the ATM module installed in slot 8 of the BlackDiamond switch.
config sonet signal label CF ports 8:1

Resetting SONET Configuration Parameter Values

To reset the SONET configuration parameters for the specified ATM ports to their
default values, use the following command:
unconfig sonet ports <portlist>

Displaying SONET Status Information on ATM ports

To display SONET status information for the ATM ports, use the following command:
show sonet {<portlist>} {detail}
You can use the optional parameter to narrow the range of status information
portlist
the command displays; otherwise, the command displays the status information for all
ports.
By default, the command displays a summary of status information for the specified
ports. You can use the optional keyword to display detailed status information
detail
for the specified ports.
The summary of status information includes the following information for each port:
• Values of all port configuration parameters
• Port state
• Any active events
The detailed status information includes the summary information plus any SONET
statistics (listed and described in Table 3-5).
3-20 Asynchronous Transfer Mode (ATM) Module Installation and User Guide