Commands And Functions Not Supported; Summary Of Commands Not Supported For Atm Ports - Extreme Networks BlackDiamond 6800 Installation And User Manual

Commands and Functions Not Supported

None of the ExtremeWare commands associated with the following functions are
supported for ATM ports:
• Extreme Standby Routing Protocol (ESRP)
• Dynamic Link Context System (DLCS)
™
• Intra-Subnet QoS
• Remote Monitoring (RMON)
Table A-4 is an alphabetical list of the existing ExtremeWare commands that are not
supported for the ATM module.
Table A-4: Summary of Commands Not Supported for ATM Ports
Command
config gvrp [listen | send | both | none]
ports <portlist>
config mirroring add [vlan <name> |
port <port> | vlan <name> ports <portlist>
config ports <portlist> auto off {speed [10 |
100 | 1000]} duplex [half | full]
config ports <portlist> auto on
config vlan <name 1 > [add | delete]
ports <portlist> {tagged | untagged}
{nobroadcast}
2
config vlan <name > protocol
<protocol_name>
disable learning ports <portlist>
enable dlcs ports <portlist>
enable esrp vlan <name>
A-6
(ISQ)
Description
The Generic VLAN Registration Protocol (GVRP)
is not supported on ATM module ports.
Port mirroring is not supported on ATM module
ports.
This command is an Ethernet-specific command.
This command is an Ethernet-specific command.
Usage restrictions apply. ATM I/O module ports
do not support Protocol-Based VLANs or MAC
Address VLANs; otherwise, ATM ports support
the optional tagged and untagged keywords
when BCP is enabled and ignore them when
IPCP is enabled.
Usage restrictions apply. The command
config vlan <name> protocol any is
supported, because it can be used to configure
the default VLAN for ATM ports.
Learning is always enabled.
No DLCS functions are supported for an ATM
port when the port is a member of a VLAN.
Not supported when an ATM port is a member of
the VLAN specified as <name>.
Asynchronous Transfer Mode (ATM) Module Installation and User Guide