Configuring Rsvp-Te; Commands For Configuring Rsvp-Te - Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual

Configuring RSVP-TE

is not enabled. The bundle-time value can be set to any value between zero and 30
(or 3 seconds).
Configuring RSVP-TE
This section describes the following tasks:
• Configuring RSVP-TE on a VLAN on page 5-16
• Configuring RSVP-TE Protocol Parameters on page 5-17
• Configuring an RSVP-TE Path on page 5-18
• Configuring an Explicit Route on page 5-19
• Configuring an RSVP-TE Profile on page 5-20
• Configuring an Existing RSVP-TE Profile on page 5-22
• Configuring an RSVP-TE LSP on page 5-23
• Adding a Path to an RSVP-TE LSP on page 5-23
• Displaying RSVP-TE LSP Configuration Information on page 5-24
• Displaying the RSVP-TE Routed Path on page 5-25
• Displaying the RSVP-TE Path Profile on page 5-25
• Displaying the RSVP-TE LSP on page 5-25

Commands for Configuring RSVP-TE

Table 5-2 describes the ExtremeWare commands for configuring and monitoring
RSVP-TE. Each command is described in detail in the sections that follow.
Table 5-2: RSVP-TE Configuration Commands
Command
config mpls add vlan [<name> | all] {rsvp-te}
config mpls delete vlan [<name> | all]
{rsvp-te}
5-14
Description
Enables RSVP-TE for one or all VLANs. If not
specified, RSVP-TE is enabled on the specified
VLAN.
Disables RSVP-TE on one or all VLANs. If not
specified, RSVP-TE is disabled for the specified
VLAN.
MPLS Module Installation and User Guide