Changed Commands - Extreme Networks BlackDiamond 6800 Installation And User Manual

Table A-1: New ExtremeWare Commands (continued)
Command
config sonet threshold signal degrade
<error_rate> ports <portlist>
config sonet threshold signal fail <error_rate>
ports <portlist>
config sonet trace path <id_string>
ports <portlist>
config sonet trace section [<id_byte> |
string <id_string>] ports <portlist>
show atm {<portlist>}
show atm pvc [<vpi | vci> | all] {vlan
<name>} {<portlist>}
show sonet {<portlist>} {detail}
unconfig diffserv dscp-mapping
ports <portlist>
unconfig atm ports <portlist>
unconfig sonet ports <portlist>

Changed Commands

Changes to existing ExtremeWare commands fall into two categories:
• Syntax enhancements to support the ATM module
• Implementation changes to support the ATM module
Syntax changes are visible: keywords or arguments may have been added or changed to
make it possible to configure the behavior associated with the ATM module.
Implementation changes may be visible, taking the form of different input behavior,
such as blocking an attempt at specifying an ATM port for a given command, or in
additional information in the results of a command, such as in a
Commands not described in this section are supported by the ATM module as
described in the ExtremeWare Software User Guide.
Asynchronous Transfer Mode (ATM) Module Installation and User Guide
Description
Configures the Signal Degrade threshold for the
specified ATM ports.
Configures the Signal Failure threshold for the
specified ATM ports.
Configures the Path Trace Identifier string for the
specified ATM ports.
Configures the Section Trace Identifier for the
specified ATM ports.
Displays ATM port status
Displays PVC status.
Displays the status of SONET features on ATM
ports.
Resets the DSCP mapping tables for the
specified ATM ports to their default values.
Resets the configuration parameters of the
specified ATM port to their default values.
Resets the SONET configuration parameters of
the specified ATM port to their default values.
Changed Commands
command.
show ports
A-3