Additional Atm Module Support Topics; Configuring General Switch Attributes - Extreme Networks BlackDiamond 6800 Installation And User Manual

Additional ATM Module Support Topics

This section describes additional command and configuration information related to the
use of the ATM module. This section includes information on the following topics:
• Configuring General Switch Attributes on page 3-45
• Configuring Port Attributes on page 3-46
• Configuring IGMP Attributes on page 3-48
• Configuring Layer 2 and 3 Switching Attributes on page 3-49
• Configuring Access List Attributes on page 3-49
• Changing Image and Configuration Attributes on page 3-49

Configuring General Switch Attributes

Except as described below, the ATM module supports all of the general ExtremeWare
switch commands. Table 3-13 describes the changes to existing ExtremeWare general
switch commands to support the ATM module. Commands with keywords or
parameters shown in italic typeface are existing ExtremeWare commands that have been
enhanced to support the ATM module.
Table 3-13: Changes to General Switch Commands
Command
show slot {<slot>}
config slot <slot> module [a3c | f32t | f32f |
f48t | g4x | g6x | g8x | g12x | p3c | p12c |
wdm]
show version
Asynchronous Transfer Mode (ATM) Module Installation and User Guide
Additional ATM Module Support Topics
Description of Change
Augmented implementation: For the ATM
module, the information displayed by this
command will include data about the software
images loaded on the module, as well as network
processor and GPP status.
Enhanced command: The a3c keyword
represents the OC-3c/STM-1 ATM module.
Augmented implementation: The information
displayed by this command will include data
about the ATM module and the bootrom version
of the ATM module.
3-45