Configuring the ATM Module
Configuring VLAN-Related Attributes
The ExtremeWare software and the Extreme Networks switch architecture provide a
range of Virtual Local Area Network (VLAN) features, which are described in detail in
the ExtremeWare Software User Guide. This section describes how these features are
supported on the ATM module.
This section assumes some familiarity with the Extreme Networks
implementation of VLAN features as described in the ExtremeWare Software
User Guide. For more information about VLAN-related features supported by
ExtremeWare, see the ExtremeWare Software User Guide.
This section provides information on the following topics:
• Summary of VLAN-Related Commands on page 3-24
• Configuring Tagged VLAN 802.1p and 802.1Q Functions on page 3-25
• Generic VLAN Registration Protocol Functions on page 3-28
Summary of VLAN-Related Commands
Table 3-7 lists the ExtremeWare VLAN-related commands that support the ATM
module. Each command is described in detail in the sections that follow.
Table 3-7: VLAN-related Commands
Command
config dot1q tagmapping
<input_vlanid/output_vlanid> ports <portlist>
{egress {priority <priority>} |
ingress {priority <priority>}}
config dot1q tagnesting {<vlanid> |
<vlanid_range>} [off | pop |
push <new_vlanid> {priority <priority>}]
ports <portlist> {egress | ingress}
ATM module ports do not support protocol-based VLANs or MAC address VLANs.
Thus, there are restrictions on the use of the following commands:
•
config vlan <name> [add | delete] ports <portlist> {tagged | untagged}
{nobroadcast}
3-24
Description
Configures the VLAN tag mapping tables for an
ATM port.
Configures the VLAN tag nesting attributes for an
ATM port.
Asynchronous Transfer Mode (ATM) Module Installation and User Guide