Comtech EF Data XTD-750C-B1 Operation And Installation Manual page 126

MNC-0000-041
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
and the net mask if "Static IP" is selected. If DHCP is selected, a
server on your network assigns the IP address.
Improper selection of IP addresses in Static IP mode
may affect the proper operation of your Local Area
Network; the use of DHCP mode is strongly advised.
10. The last option on the configuration menu is either "Display –
Watts" or "Display – dBm" depending on the current units used
for power. Selecting this option allows you to toggle power units
for Forward Power, Reverse Power, and the Power Alarms.
Figure 11, Ethernet Configuration
11. Refer to Figure 12 on page 13. The communications menu
allows you to Use Ethernet for M&C operation. If this option is
selected, all M&C operations are done solely over the Ethernet
connection; RS232 and RS485 modes are not used.
12 of 34
Operation Addendum, HPA Control Utility
Note
Revision A