Invacare LiNX DLX-REM110 User Manual page 29

Please cycle the power prior to charging if wheelchair
has not been used within 24 hours. This will ensure
the enhanced battery gauge registers the charge to
give an accurate reading during use of wheelchair. If
it is not powered up, the battery gauge does not
indicate the charging state. For more information
about the charging state, see user manual of your
charger.
1. Plug the battery charger into the remote's charger
socket A.
If the remote is powered up, the battery gauge indicates
the system is connected to the charger by cycling between
a left-to-right chase sequence, and then displaying the
approximate battery charge state at the end of the chase
sequence.
1602969-F
Fig. 5-9
Battery charge state 1
Red LED on.
Battery charge state 2
Red and one amber LED on.
Battery charge state 3
Red and two amber LEDs on.
Battery charge state 4
Red, amber and one green LED on.
Fully charged
Green, green, amber, amber and red
LEDs on.
For more information about the drive inhibit mode, see 6.3
Drive inhibit indication, page 34.
Usage
29