Set-Up And Adjustments; Box Width Adjustment; Box Height Adjustment; Changing The Tape Leg Length - 3M 40800 Instructions And Parts List

11 - SET UP AND ADJUSTMENTS

11.1 Box Width Adjustment

Boxes are automatically centered by the Side
Guides (Figure 11-1). The Side Guides are trig-
gered by the Centering Guide Switch which is lo-
cated on the machine bed. Side Guides air pressure
adjustments can be made using the Centering Guide
Air Pressure Regulator (See Figure 9-8).

11.2 Box Height Adjustment

Box Height is automatically determined when the
Upper Drive Assembly Actuator Switch is engaged
which is located on the front of the Upper Drive As-
sembly (See Figure 11-2). .The Upper Drive air pres-
sure adjustments can be made using the Center-
ing Guide Air Pressure Regulator (See Figure 9-8).
11.3 Adjustment of Top Flap Compression
Rollers (Not Applicable to this Machine)

11.4 Changing the Tape Leg Length

Taping heads are preset to apply 70mm [2.75 inches]
long tape legs. To change tape leg length to 50mm
[2.0 inches], refer to Instructions below and also to
Manual 2, "Removing Taping Heads Procedure -
Changing the Tape Leg Length".
With upper drive assembly in raised position:
1. Remove tape from upper taping head.
2. Pivot up the clamp that secures the upper taping
head.
3. Hold upper taping head applying and buffi ng
arms from under upper assembly, slide head
forward and down to remove. See Figure 11-3.
4. Lift the lower taping head, shown in Figure 11-4,
straight up to remove it from the case sealer
bed.
5. Refer to Section II, "Adjustments – Changing
Tape Leg Length," for taping head set-up.
6. Replace taping heads reverse of disassembly.
Turn on air supply and electric power, unlatch
upper drive assembly and allow it to return to its
rest position.
Figure 11-1
700rks-NA
Figure 11-2
Figure 11-3 – Remove Upper Taping Head
Figure 11-4 – Remove Lower Taping Head
37
Upper Drive
Actuator Switch
2010 January