Epson GQ-3500 User Manual page 97

ESC c
Format:
ASCII code:
Decimal:
Hexadecimal:
Comments:
Changes the character pitch to that specified by the value of n as
shown in the following table. If the specified font is not available,
font is selected according to the font selection procedure.
Table A-5. Character sizes
Decimal
48
50
53
51
ESC *
Format:
ASCII code:
Decimal:
Hexadecimal:
Comments:
Specifies the print pitch (character spacing), which determines the
distance from the left edge of one character cell to the left edge of
next one. If ESC SP (intercharacter spacing) is set with a value more
than 0, the distance between the characters will be the value of ESC SF'
plus the value in the ESC, command. If nl=O,
each character is used. If nl=l the pitch specified by n2 and n3 is
selected and characters are printed in that pitch. The distance is
specified in units of the minimum increment (specified by ESC q>, using
the formula: total distance = IQ + (n3 x 256). This command does
work if you are using proportional spacing.
Page Printer Commands
ESC c
27 99
63
Hex Pitch
30
10 characters per inch
32
12 characters per inch
35
15 characters per inch
33
13 characters per inch
ESC
27
2C
Select Character Set bv Pitch
n
n
n
nl (n2 n3)
(n2
nl n3)
pitch assigned to
the
the
Select Pitch
the
not
A - 2 1