Epson GQ-3500 User Manual page 107

When a form is to be printed starting at a specific location on a page,
you should specify the print position at the beginning of the form.
When using this comman d to delete a form, the command must not be
used on the current page. After printing of a form, the active print
position is located immediately after the last print position in the
form.
ESC 1
Format:
Hexadecimal:
Comments:
Selects printing using a form defined with ESC (. The following values
can be used for n1:
1: Mode is turned ON.
0: Mode is turned OFF.
The value of n2 must be from 1 to 8; it specifies the number of the form to
be printed. When overlays are on, the selected form is automatically
printed at the beginning of each page until printing is stopped by using
this command with 0 specified for nl.
Graphics
ESC n
Format:
ASCII code:
Hexadecimal:
Comments:
Defines a background which can be used with ESC - or PAINT
command. The value of nl specifies the number of the background being
defined; it must be 7 or 8. Following nl are sixteen pairs of characters
The background pattern is defined as a square of 16 dots by 16 dots.
Each row of dots is specified by two bytes, starting at the top.
Page Printer Commands
Turn Forms Overlay PrintinP On/Off
ESC
27 125
7D
ESC n
27 110
6E
nl n2
nl n2
n2
nl
Define BackPround
n
d l
n
d l
n d l
. . .
d32
. . . d32
. . .
d32
A - 3 1