Epson GQ-3500 User Manual page 86

ESC 0
Format:
Hexadecimal:
Comments:
Sets the line spacing to 1/8th of an inch for subsequent line feed
commands. The "0" is the character zero (30 hex) and not ASCII code 0.
When a line feed is made after setting the line spacing to 1/8th of an
inch, the reference point for positioning is the bottom edge of the
immediately preceding line space.
ESC 2
Format:
ASCII code:
Hexadecimal:
Comments:
Sets the line spacing to l/6 of an inch for subsequent line feed commands.
The "2" is the character two (32 hex) and not ASCII code 2. This is the
default at power on.
When a line feed is made after setting the line spacing to 1/6th of an
inch, the reference point for positioning is the bottom edge of the
immediately preceding line space.
ESC A
Format:
Decimal:
Hexadecimal:
Comments:
Sets the line spacing to n/60 of an inch for subsequent line feed
commands. The value of n must be from 0 - 127.
When a line feed is made after setting the line spacing with this
command, the reference point for positioning is the bottom edge of the
immediately preceding line space.
This command changes the character baseline as well as the line
spacing. The baseline is set at the point that is 3/4ths of the distance
from the top edge of the line space to the bottom edge.
If the line spacing is changed in the middle of a line the characters on
that line may not align properly.
A-10
ESC 0
27 48
30
ESC 2
27 50
32
ESC A
27
65
41
Select I/8-inch Line Spacing
Select l/641& Line Spacing
Select n/60-inch Line Spacing
n
n
n
Page Printer Commands
-