Epson GQ-3500 User Manual page 162

alternating with a two-digit number indicates a problem that may
1
require
following status message.) Turn the printer off for a few seconds, then
turn it back on. If the same error recurs, then write down the full
number displayed (such as E 1 8LJ), turn off the power, and contact a
qualified service representative.
IC card installation error. Turn off
IC card. If the error recurs, contact a qualified service-representative.
Paper feed jam. See that the paper set lever is up. If it is up, press it
down and remove the jammed paper. Raise the lever and press the
ERROR CLEAR
Paper transport
Gently remove the jammed paper, then lower and lock the unit into
place. Close
warmed up.
J 2
Paper exit jam. See instructions for paper transport jam.
Buffer overflow; overflow
ERROR CLEAR
Page composition error; some characters may be lost. Press the
ERROR CLEAR
When the printer is off line and
prints
This status message is displayed while the printer is printing in this
way.
Paper out. See Chapter 4 for details on adding paper.
Paper size being
the setting or change the paper to make the setting and paper size
match.
Change the toner cartridge. (See Chapter 5 for details.)
Replace the collector unit and lens shield. Press the reset lever before
closing the cover.
Replace the drum cartridge and lens shield. Press the reset lever
before closing the cover.
call. (For error code E 1 Cd in particular, see the
a service
button.
Open the printer and lift the processing unit.
jam.
and resume printing when the printer has
the case
button.
button.
received data when the
the
does
used
power and properly install the
the
will
characters not
light is flashing the printer
the DATA
PAPER FEED
paper size selected. Change
not match
be printed. Press the
button is pressed.