Epson GQ-3500 User Manual page 59

6. Now change the lens shield. First, pull the shield out from below
the latch on the front of the printer. Next, make sure that both
sides of the new lens shield are clean and free of scratches. (Hold
onto the green tab so the tab curves down; avoid touching
itself.) Slide the end of the lens opposite the green tab into the
printer. (See Figure 5-10.)
Figure 5-10. Replacing the lens shield
7. Close the printer.
When the drum cartridge requires replacement, the status indicator
displays ~2 and the
operation stops after ejection of the page being printed. To replace the
drum cartridge and lens shield, follow these steps:
WARNING
This procedure will expose the drum. Because the drum is light-
sensitive, it should not be exposed to lighting brighter
room light. Room light exposure should not exceed five minutes.
(Completing this procedure in less than five minutes should be
problem.) Also, be careful not to touch the drum surface.
1. Open printer by releasing the latch on the front of the printer.
the
Maintenance and Status Messages
USER MAINTENANCE
indicator lights. Printer
normal
than
lens
the
no
5 - 1 3