Hazardous Situations And Appropriate Actions - Pentair BIOSHIELD CLP41A6-XN Installation And User Manual

IMPORTANT: Close supervision is necessary when any appliance is used by or near children, this UV
IMPORTANT: Always unplug the unit from the electrical outlet when it's not in use, before servicing,
IMPORTANT: Each UV system is designed for a specific water-pressure. DO NOT use the UV system
IMPORTANT: Only (3) three wire grounded cables suitable for outdoor use should be used to connect
IMPORTANT: Only operate the UV system when it is properly maintained and in good working order.
IMPORTANT: DO NOT modify the UV system without authorization from Pentair.
DANGER:
Hazardous Situations & Appropriate Actions
Situation
Lamp or Quartz Sleeve
Removal
Broken Quartz Sleeves/
UV Lamps
UV Lamp
Replacement
Drain UV Vessel
Vessel Cleaning
Electrical Work
system is no exception.
cleaning or removing parts. Never yank the cord to pull the plug from the outlet. Grasp
the plug and pull to disconnect.
for any application other than its intended use. The use of attachments not
recommended or sold by Pentair Commercial Aquatics
possibly void any warranty.
this unit. If joining cables for outdoor use, a suitable watertight cable connector must be
used. If an extension cord is necessary, a cord with a proper rating should be used. A
cord rated for less ampere or watts than the appliance's rating may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled. If in
doubt consult a qualified electrician.
BLUE-LIGHT HAZARD Ultraviolet light will cause serious damage to your eyes and
skin! DO NOT handle or stare at an operating UV lamp. UV lamps become hot during
operation, DO NOT handle them during operation.
Location Hazard
UV Vessel Burn
UV Vessel Sharp Object
UV Vessel Blue-Light Hazard
UV Vessel Pressure
UV Vessel Corrosive/
Chemical
UV System Electrical Shock
BIOSHIELD™ Commercial UV Disinfection System Installation and User's Guide
may cause unsafe conditions and
Actions
Isolate UV system from water source,
shutdown system using external On/
Off switch and lock-out disconnect
from input power source.
Handle quartz sleeves and UV lamps
with extreme care, wear clean cotton
gloves.
DO NOT operate UV lamps outside the
UV vessel, wear protective eye wear
against ultraviolet light.
Isolate UV system from water source
and shutdown system using external
On/Off switch and lock-out/disconnect
from input power source. Open valves
carefully to relieve pressure and drain
the UV Vessel.
Isolate the UV vessel and secure
against unauthorized operation. Wear
appropriate protection equipment.
No smoking or food allowed.
Shutdown system using the UV
system's external On/Off switch and
lock-out/disconnect from input power
source. All electrical work should be
carried out by authorized and qualified
personnel only.
3