Water Flow Rates; Section 6: Installation; Pre-Installation Inspection - Pentair BIOSHIELD CLP41A6-XN Installation And User Manual

Pre-Installation Inspection

Purpose
To familiarize the installer/operator with the Bioshield™
UV Disinfection System components, to assure proper
delivery of all the system's components and to inspect
each component for shipping damages.
Frequency
To be con ducted prior to installation.
Parts and Required Equipment
• Adjustable Wrench or 1.5" Socket
• Box Cutter
• Hammer/Nail Remover
• Flashlight
During pre-installation there is a general risk due to load.
Quartz Sleeves and UV Lamps are fragile and potentially dangerous if broken. Handle with care.
Procedure
Note:
Vessel diameters up to 8" are shipped with their quartz sleeves assembled. Vessel diameters 10" and larger are
shipped with their quartz sleeves packaged separately.
Note:
UV Lamp(s) are shipped in a separate package either inside the vessel crate or separately.
1. Unpack and inspect vessel for shipping damage. A box cutter or hammer/nail remover may be needed to unpack the
UV System.
2. Conduct an internal, visual inspection of models shipped with their quartz sleeves assembled. A flashlight will help with
the internal inspection.
The UV System consists of:
• Quartz Sleeve Module (QSM) Faceplate (assembled on Vessel)
• QSM Faceplate Gasket (assembled on Vessel)
• UV Intensity Sensor
• Temperature Sensor
• Quartz Sleeve Retainer Nut (one for each quartz sleeve)
• Quartz Sleeve Gasket (one for each quartz sleeve retainer nut)
• Drain Valve Assembly
• Quartz Sleeve (one for each UV Lamp)
• UV Lamp(s)
• Vessel
• Bolt(s) (assembled on Vessel)
• Nut(s) (assembled on Vessel)
• Washer(s) (assembled on Vessel)
• 4-Pin Connector(s) (attached to lamp cables)
• Lamp Field Safety Cover and Cable
BIOSHIELD™ Commercial UV Disinfection System Installation and User's Guide
SECTION SIX
INSTALLATION
NOTE: Flange mating halves not
supplied.
9