Notices; Important Safety Instructions - Epson Stylus Photo RX700 Basics Manual

Epson stylus photo rx700: user guide
Hide thumbs Also See for Stylus Photo RX700:
Table of Contents

Advertisement

Notices

Important Safety Instructions

Before using your Epson Stylus Photo RX700, read and follow these safety instructions:
Be sure to follow all warnings and instructions marked on the Stylus Photo RX700.
Use only the type of power source indicated on the Stylus Photo RX700 label.
Connect all equipment to properly grounded power outlets. Avoid using outlets on
the same circuit as air control systems or other high-load devices that regularly switch
on and off.
Place the Stylus Photo RX700 near a wall outlet where the plug can be easily
unplugged.
Do not let the power cord become damaged or frayed.
If you use an extension cord with the Stylus Photo RX700, make sure the total
ampere rating of the devices plugged into the extension cord does not exceed the
cord's ampere rating. Also, make sure the total ampere rating of all devices plugged
into the wall outlet does not exceed the wall outlet's ampere rating.
Avoid electrical outlets controlled by wall switches or automatic timers.
Keep your Stylus Photo RX700 and computer system away from potential sources of
electromagnetic interference, such as loudspeakers or cordless telephone base units.
Avoid locations that are subject to rapid changes in heat or humidity, shocks or
vibrations, or dust.
Leave enough room around the Stylus Photo RX700 for sufficient ventilation.
Do not place the Stylus Photo RX700 near a radiator or heating vent or in direct
sunlight.
Place the Stylus Photo RX700 on a flat, stable surface that extends beyond its base in
all directions. It will not operate properly if it is tilted. If you place this product by a
wall, leave at least 4 inches (10 cm) between the back of the product and the wall.
Turn off and unplug the Stylus Photo RX700 before cleaning. Clean with a damp
cloth only. Do not spill liquid on it.
Always turn the Stylus Photo RX700 off using the P On button. Don't turn off
the power using a switch on a power strip or unplug the Stylus Photo RX700 until
the P On light and LCD panel turn off.
85

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents