Table of Contents
Advertisement
Preparing the library for long-distance relocation
1.
Unload all tape cartridges from the tape drives using your application software.
2.
Power off the library.
3.
Unlock and open the front door.
4.
Remove all tape cartridges from the library bins.
5.
Carefully pack all tapes for shipment.
6.
Install shipping restraints on the robot (see
7.
Disconnect library cables from hosts, switches, or local networks and pack them with other library
accessories.
8.
If the library needs to be crated, proceed to the next section.
Repacking the library
Use this section if you need to:
•
Ship the library to the new site.
•
Transport the library by forklift or similar means.
WARNING!
To pack the library for a new site (see
3
1
Ramps
2
Corner posts
3
Corrugated sheets
Figure 56
Repacking the library
98
Moving the library
Use at least two people to perform any steps that involve lifting or guiding the library.
2
2
1
6
6
4
Cap
5
Antistatic bag
6
Shock pallet
Figure 35
on page 50 for location).
Figure
56):
4
5
2
2
2
3
gl01013
Advertisement
Table of Contents
Troubleshooting
