Status Screen; Ocp Status Screen - HP E Series User Manual

Status screen

The Status screen
describes the information you can obtain from these status screens.
Power supplies, load ports, tape drives, and interface controllers are all numbered from top to bottom in
the rack. However, power supplies are numbered by slot, so if a slot is not filled with a power supply, the
slot still receives a number. For example, the highest power supply slot in the rack is power supply 1. The
next lower power supply slot is power supply number 2. If a power supply is on the same level
horizontally (like those in the card cage expansion module), the one to the right (facing the back of the
rack) has the next highest number. If a component is removed, the numbering does not change until the
library is rebooted. After a reboot, all components are rediscovered and reassigned numbers from top to
bottom.
Figure 40

OCP Status screen

Table 4 Status screen functions
Function
Identity Screen
Health Summary
(Figure 40) provides access to the current state of every EML component.
Description
Contains basic configuration information. The library name and IP address is
obtained from Command View TL. Other information comes from the robot firmware.
The number of interface controllers and drives installed in the library are listed, as
well as the total number of available storage slots. For example, load port slots
configured as storage slots are counted in the total of available slots, while load
ports used to move media in and out of the library are not counted in the total.
This screen also shows the library model, library serial number, and library
firmware version.
Displays a status icon and health information for the library, robot, power supplies,
load ports, drives, interface controllers, and Interface Manager card.
Enterprise Modular Library E-Series user guide
Table 4
59