Removing The Memory Module From The Interface Manager Card - HP E Series User Manual

Hide thumbs Also See for E Series:
Table of Contents

Advertisement

b. Grasp the edges of the memory module and slide it out of the flash memory slot. If needed, push a
pen into the corner notches of the flash memory slot to unseat the memory module.
2
3
1
Interface Manager card
2
Flash memory slot
Figure 52

Removing the memory module from the Interface Manager card

c. Remove the replacement Interface Manager card from its protective sleeve and place it on your
work surface (facing battery-side up).
d. With the connector going in first, align the sides of the memory module with the flash memory slot
on the replacement Interface Manager card. Gently slide the memory module into the slot until it is
securely seated.
e. If the memory module does not slide in easily, the module is upside down. Pull the module back
out, flip it over, and re-insert it into the slot.
To install the replacement Interface Manager card:
1.
Align the replacement Interface Manager card with the guides in the base module card cage and slide
the card into the library. Tighten the captive screws.
2.
Reconnect the cables to the interface controller exactly as they were connected to the original board.
3.
Power on the library:
a. Set the library power switch at the upper right corner to the On position (see
page 69).
b. Observe that all power indicators on the power supplies show that power was restored.
c. Verify that the library robotics controller ACTIVE indicator is lit (see
4.
Verify that the status LEDs indicate a normal state (see
NOTE:
Because all the configuration settings of the Interface Manager card are stored in the memory
module that you replaced earlier, your replacement Interface Manager card retains the configuration of
the original card. To verify or change these settings, see the HP StorageWorks Interface Manager and
Command View TL user guide.
5.
Close the back door of the library.
The Interface Manager card replacement is complete.
1
gl10032
3
Memory module
Table 9
Enterprise Modular Library E-Series user guide
Figure 48
Figure 46
on page 67).
on page 66).
on
87

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ad560–96002

Table of Contents