Split Tone Operation - Yaesu VX-8GR/GE Operating Manual

CTCSS/DCS/EPCS B
12. When you wish to add a beep tone into the beep melody
strings, move the cursor to the place where you wish to en-
ter the beep tone using the B/M key, then press the
c key repeatedly until the "SELECT" notation in the "Op-
eration Mode" slot turns into "INSERT". Now, press and hold in the c key for one
second to add the new beep tone (Tone: "C2", Tone Length: "500mS").
13. Press and hold the h key for one second to delete all data after the current position
that may have previously been stored in the User Beep Melody.
14. When you have programmed User Beep Melody, press the PTT switch briefly to save
the new setting and exit to normal operation.
You may check your work by monitoring the programmed User Beep Melody.
To do this, repeat steps 1 - 4 above, then press the f key.
The VX-8GR/GE can be operated in a Split Tone configuration via the Set mode.
1. Press and hold the m key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item 87: SQL
SPLIT.
3. Press the m key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select "ON" (to enable the Split
Tone feature).
5. Press the PTT switch briefly to save the new setting and
exit to normal operation.
When the Split Tone feature is activated, you can see the following additional parameters
after the "MESSAGE" parameter while selecting the Set Mode Item 88: SQL TYPE:
D CD:
TONE-DCS:
D CD-TONE SQL: Encodes a DCS code and Decodes a CTCSS Tone
Select the desired operating mode from the selections shown above.
VX-8GR/GE O
PERATING
CTCSS/DCS/EPCS O
S T
PLIT ONE
DCS Encode only ("DC" icon will appear while operating)
Encodes a CTCSS Tone and Decodes a DCS code
(the "T-D" icon will appear during operation)
(the "D-T" icon will appear during operation)
M
ANUAL
O
ELL PERATION
O
PERATION
PERATION
39