Split Tone Operation - Yaesu FTM-7250DR Advance Manual

Advanced Operation

Split Tone Operation

The FTM-7250DR can be configured to operate in a "Split Tone" system via the Setup
menu, to facilitate operation on repeaters using a mix of both CTCSS and DCS control.
1. Press and hold the [ MHz ( SETUP )] key to enter the
Set mode.
2. Rotate the DIAL knob to select "SQL EXP 43".
3. Press the [ MHz ( SETUP )] key, then rotate the
DIAL knob to select "ON".
Default: OFF
4. Press the [ MHz ( SETUP )] key momentarily, then
rotate the DIAL knob to select "SQL TYPE 44".
5. Press the [ MHz ( SETUP )] key, and then rotate the
DIAL knob to select the following parameters.
D CODE: DCS Encode only (the "DCS" icon will
blink during operation)
T DCS: Encodes a CTCSS Tone and Decodes
a DCS code (the "T" icon will blink and
the "DCS" icon will appear during oper-
ation)
D TONE: Encodes a DCS code and Decodes a
CTCSS Tone (the "T SQ" icon will ap-
pear and "DCS" icons will blink during
operation)
6. Press and hold the [ MHz ( SETUP )] key to save the new setting and exit to normal
operation.
9