Message Alert Tone - AT&T TL87203 User Manual

Answering system
Answering system settings

Message alert tone

When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it, the
message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
Using the telephone base:
1. When the telephone base is in idle mode, press
to enter the main menu.
SELECT
2. Press
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Mailbox 1 or Mailbox 2, and then press
SELECT
.
4. Press CID, DIR, /RECORD, or /DELETE to
highlight Ans system setup, and then press
5. Press CID, DIR, /RECORD, or /DELETE to
highlight Msg alert tone, and then press
6. Press CID, DIR, /RECORD, or /DELETE to choose On or Off.
SELECT
7. Press
NOTES:
The message alert tone beeps only if all the following conditions are met:
X
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
To temporarily turn off the message alert tone, see page 133.
X
to select Answering system.
to save the setting. You hear a confirmation tone.
MENU
SELECT
SELECT
.
130
ANS SYSTEM SETUP
# of rings
Remote code
Msg alert tone
p
BACK
q
MSG ALERT TONE
On
Off
p
.
BACK
q
SELECT
SELECT