Networking - Shure MXA910-60CM User Manual

Ceiling array
Hide thumbs Also See for MXA910-60CM:
Table of Contents

Advertisement

Priority
Usage
Medium (3)
Audio, PTP
Low (2)
(reserved)
None (1)
Other traffic
Note: Switch management may vary by manufacturer and switch type. Consult the manufacturer's product guide for specific configuration details.
For more information on Dante requirements and networking, visit www.audinate.com.
Networking Terminology
PTP (Precision Time Protocol): Used to synchronize clocks on the network
DSCP (Differentiated Services Code Point): Standardized identification method for data used in layer 3 QoS prioritization

Networking

Networking Best Practices
Use the following best practices when setting up a network to ensure reliable communication:
Always use a "star" network topology by connecting each component directly to the switch or router.
Connect all Shure networked devices to the same network and set to the same subnet. It is also required in order to
open the web application for a device.
Devices on separate networks require an audio processor or conferencing software to carry audio between them. See the
system planning and gear requirements section for network setup information and configuration examples.
Use only 1 DHCP server per network. Disable DHCP addressing on additional servers.
Power on the switch and DHCP server prior to MXA equipment.
To expand the network, use multiple Ethernet switches in a star topology.
All devices must be at the same firmware revision level.
Network Audio and Shure Control Data
MicroflexAdvance devices transport two types of data over the network: Shure Control and Network Audio.
Shure Control
The Shure Control carries data for the control software operation, firmware updates and 3rd party control systems (AMX,
Crestron).
Network Audio
This network carries both the Dante digital audio and the control data for Dante Controller. The network audio requires a
wired, gigabit Ethernet connection to operate.
Device IP Settings
Configure IP
Sets IP mode of the selected network interface:
Auto (DHCP): For automatic assignment of IP addresses.
Manual (Static): For Static IP addresses.
IP Settings
DSCP Label
Hex
EF
0x2E
CS1
0x08
BestEffort
0x00
Decimal
Binary
46
101110
8
001000
0
000000
Shure Incorporated
48/59

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mxa910Mxa910w-a

Table of Contents