Table of Contents
Advertisement
3.
Paint the frame and grille section and allow it to completely dry before reassembling. Do not paint any part of the main
assembly.
Step 3: Reassembly
1.
Secure the foam piece with the hook-and-loop fastener strips around the edges.
2.
Slide the grille back into the frame.
3.
Attach the remaining side of the frame and secure it with the 4 screws.
4.
Attach the LED lightpipe into the black plastic guide piece.
5.
Align the LED with the lightpipe and put the assembly back in place on the frame.
Note: The label on the assembly is placed on the corner that corresponds to the LED. Use it for reference to ensure proper orientation during re
assembly.
6.
Install the screws (6 per side) to secure the main assembly to the frame. Do not over-tighten.
Cable Management
To keep the Ethernet cable out of view, use the appropriate method based on the installation type.
Installation
Ceiling grid
VESA (pole mounting)
4-point wire suspension
Hard ceiling
Note: If using conduit to contain the cable, the optional junction box accessory (model A910-JB) mounts directly to the rear panel of the microphone.
Note: For ceiling grid installations, see the Notice or visit https://shu.re/QandA.
(2.1) Masking off the extrusion (highlighted in black)
Cable Solution
Run the cable above the ceiling grid
Guide the cable through the pole to run it above the ceiling
grid
Use cable ties to attach the CAT5 cable along one of the
hanging wires
Run the cable above the ceiling
Shure Incorporated
29/59
Advertisement
Table of Contents
