Shure MXA910-60CM User Manual page 49

Ceiling array
Hide thumbs Also See for MXA910-60CM:
Table of Contents

Advertisement

View and edit the IP Address, Subnet Mask, and Gateway for each network interface.
MAC Address
The network interface's unique identification.
Configuring IP Settings
IP configurations are managed in Shure Designer software. By default, they are set to Automatic (DHCP) mode. DHCP mode
enables the devices to accept IP settings from a DHCP server, or automatically fall back to Link-Local settings when no DHCP
is available. IP addresses may also be manually set.
To configure the IP properties, follow these steps:
1.
Open device's configuration window.
2.
Go to the Settings tab and select Network.
3.
Select Auto or Manual. If Auto is used, addresses will be automatically assigned. For Manual setup, follow the instruc­
tions on manual configuration.
Manually Assigning Static IP Address
To manually assign IP addresses, follow these steps:
1.
Open the device's configuration window in Designer.
2.
Go to the Settings tab and select Network.
3.
Select Manual as the Configure IP setting.
4.
Enter the IP settings.
Setting Latency
Latency is the amount of time for a signal to travel across the system to the outputs of a device. To account for variances in la­
tency time between devices and channels, Dante has a predetermined selection of latency settings. When the same setting is
selected, it ensures that all Dante devices on the network are in sync.
These latency values should be used as a starting point. To determine the exact latency to use for your setup, deploy the set­
up, send Dante audio between your devices, and measure the actual latency in your system using Audinate's Dante Controller
software. Then round up to the nearest latency setting available, and use that one.
Use Audinate's Dante Controller software to change latency settings.
Latency Recommendations
Latency Setting
0.25 ms
0.5 ms (default)
1 ms
2 ms
Operating the Control Software over Wi-Fi
When operating the web application over Wi­Fi, it's important to set up the wireless router properly for best performance. The
system employs several standard­based protocols that rely on multicast. Wi­Fi treats broadcast and multicast packets different­
Maximum Number of Switches
3
5
10
10+
Shure Incorporated
49/59

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mxa910Mxa910w-a

Table of Contents