Table of Contents
Advertisement
Mute LED Behavior
The lighting for mute and active microphone states is configurable to match the behavior of other devices in conference rooms.
In the LIGHT BAR PROPERTIES menu, use the drop-down menus to select LED settings.
Dimming and Disabling
To dim or turn off the LED, use the brightness fader.
Reset Button
The hardware reset button is located inside a grille hole and can be pushed with a paperclip or other small tool. The hole is
identified with a gray circle. When looking at the Shure logo, it is the second hole in the fourth row from the top.
Reset Modes
Network reset (press button for 4-8 seconds)
Resets all Shure control and audio network IP settings to factory defaults.
Full factory reset (press button for longer than 8 seconds)
Restores all network and web application settings to the factory defaults.
Software Reset Options
To simply revert settings without a complete hardware reset, use one of the following options:
Reboot Device (Settings > Factory Reset): Power-cycles the device as if it were unplugged from the network. All settings
are retained when the device is rebooted.
Default Settings (Presets > Load Preset > Default Settings): Reverts audio settings back to the factory configuration
(excluding Device Name, IP Settings, and Passwords).
If you're using Shure Designer software to configure your system, please check the Designer help section for more about this topic.
Power Over Ethernet (PoE)
This device requires PoE to operate. It is compatible with both Class 0 and Class 3 PoE sources.
Shure Incorporated
18/59
Advertisement
Table of Contents
