Table of Contents
Advertisement
Sending Audio from a Shure Device
All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
1.
Open the Shure transmitting device in Dante Controller.
2.
Enable AES67.
3.
Reboot the Shure device.
4.
Create AES67 flows according to the instructions in the
Receiving Audio from a Device Using a Different Audio Network Protocol
Third-party devices: When the hardware supports SAP, flows are identified in the routing software that the device uses. Oth
erwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices: The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.
Encryption
Audio is encrypted with the Advanced Encryption Standard (AES-256), as specified by the US Government National Institute of
Standards and Technology (NIST) publication FIPS-197. Shure devices that support encryption require a passphrase to make
a connection. Encryption is not supported with third-party devices.
To activate encryption:
1.
Open the Settings menu and select the General tab.
2.
Select Enable Encryption.
3.
Enter a passphrase. All devices must use the same passphrase to establish an encrypted connection.
Important: For encryption to work:
•
All Shure devices on your network must use encryption.
•
Disable AES67 in Dante Controller. AES67 and AES-256 cannot be used at the same time.
If you're using Shure Designer software to configure your system, please check the Designer help section for more about this topic.
Automix
Automix Channel
This channel automatically mixes the audio from all selected channels to deliver a convenient, single output. To adjust the au
tomix channel settings, select the IntelliMix tab. All IntelliMix DSP blocks can be applied to the automix channel.
To use the automix channel, do the following:
1.
Send to Mix is automatically selected (blue) for all channels. To exclude channels from the automix channel and treat
them as individual direct outputs, deselect Send to Mix (gray).
2.
Route the automix channel in Dante Controller to the desired output.
Dante Controller user
guide.
Shure Incorporated
42/59
Advertisement
Table of Contents
