P2R Receiver; Controls And Features; Battery Installation; Cable Management Groove - Shure PSM200 User Manual

P2R RECEIVER

Controls and Features

1 2 3 4
5 6
1. POWER LED: Lights to indicate the unit is powered on
and blinks to indicate low battery. When this LED starts
blinking, you have approximately 15 minutes of battery time
remaining, depending on volume level and battery brand.
2. On/Off/Volume Knob: Turn clockwise past click to
power on. Continue to turn clockwise to increase volume,
counterclockwise to decrease volume.
3. LIM LED: Lights only when limiter is activated. See the
LIM LED section on page 8 for details.
4. RF LED: Lights when the unit is receiving radio
frequency(RF) signal from the P2T TransMixer.
5. Antenna: An attached, flexible whip antenna receives RF
signal from the TransMixer.
6. CHANNEL LED Indicator: Displays the number of the
current frequency channel (1-8), or the letter "A" for wired
mode. The CHANNEL LED indicator shuts itself off after
10 seconds to conserve battery life. To view the frequency
channel when the LED indicator is off, simply press and
release the SELECT button.

Battery Installation*

*Since the average life of a battery varies depending on the manufacturer, Shure recommends that youuse a fresh 9V
battery for performances longer than two hours. You can then reserve used batteries for rehearsals or other less critical
applications.

Cable Management Groove

1. Connect an audio source to the 1/4-inch MIX IN jack on the side of the P2R.
2. Attach the P2R to your belt, waist band, or another location.
3. Slide the audio cable or earphone cord up into the groove, as illustrated.
4. The belt clip will hold them securely in place.
7
8 9 10
1. Unlock the battery compartment door by pressing down
on the side of the battery compartment door marked
"OPEN" and sliding it in the direction of the arrow.
2. Flip open the door and insert a fresh 9V alkaline battery,
observing proper polarity.
3. Flip the battery compartment door closed, then press and
slide the compartment door until it snaps shut.
Note: If the battery compartment door will not close
completely, the battery is not correctly inserted.
ENGLISH
11
7. SELECT Button: Press to increment the frequency
channel or set to "A" for wired mode.
8. MIX IN Jack: Connect a 1/4-inch line-level input to this
jack. Use alone, or in combination with wireless reception
from the P2T TransMixer. See the MIX IN Jack section on
page 8 for details.
9. GAIN Switch: Slide to HI or LO position to set the sensi-
tivity of the MIX IN input.
10. Earphone Output Jack: Connect Shure earphones to
this 1/8-inch (3.5mm) jack.
11. Cable Management Groove: For a secure connection,
guide the cable connected to the MIX IN Jack or the
earphone cord into this groove.
12. Belt Clip: Securely attaches the unit to a belt, guitar strap
or waist band.
13. Battery Compartment Door: See the Battery Installation
section below.
7
12
13