Table of Contents
Advertisement
Strain relief tabs (3)
Rubber pad set
Round:
Cable ties (8)
Strain relief tabs (3)
Reset Button
The reset button is behind the grille. To push it, use a paper clip or other tool.
Button locations:
•
Square array microphones: Behind the grille hole with a silkscreened circle around it.
•
Round array microphones: Behind the first grille hole to the right of the mute status LED.
Reset Modes
•
Network reset (press for 4-8 seconds): Resets all Shure control and audio network IP settings to factory defaults. Red
LED along bar.
•
Full factory reset (press for more than 8 seconds): Resets all network and configuration settings to the factory defaults.
Multicolor flash, then blue LED along bar.
MXA920 Control Software
There are 2 ways to control the MXA920:
•
Use Shure Designer software
◦
Control all Shure devices in one place
◦
Route audio to and from Shure devices
•
Access the MXA920's web application with
◦
Control 1 microphone at a time
◦
Route audio with
Dante Controller software
Shure Web Device Discovery
Shure Incorporated
10/50
Advertisement
Table of Contents
Troubleshooting
